Cover-Plate Installation Instructions

1. Make sure the hole dimensions are : width” by height”. If the hole is too small enlarge as required. Be careful not to make the hole too large. Remove any broken “Sheetrock/ Drywall” pieces from inside the hole.

2. In the direction of the bracket, draw a mark 0.5” (1.3cm) from the edge of the hole on both sides. Remove the imperfections from the surrounding of the hole. This will allow the Cover Plate to lie flat against the wall.

3. While holding the Cover Plate as parallel to the wall (flat) as possible, push one side of the bracket inside the hole. Stop pushing when there is room for the other side of the bracket to enter the hole.

4. Using both hands slides the Cover Plate until the mark you’ve made in step 2 is covered. The Cover Plate should hides both marks you’ve made in step 2 (when installed according to these instructions).

5. The Cover Plate is firmly installed.

6. If the plate is loose after installation. Gently press on the flexible bracket arms with both thumb and re-install the Cover Plate. NOTE : To remove the plate, do the steps in reverse order. Start with step 5 and finish with 3.