Cover-Plate Installation Instructions

1. Make sure the hole size dimensions are width“ by height”. If the hole is too small enlarge as required. Be careful not to make the hole too large.

2.Remove the imperfections from the surrounding of the hole. This will allow the cover plate to lie flat against the wall.

3. Insert the cover plate at a 45 degrees angle in the wall hole. Slide the cover plate until the bracket at the back is completely inside the hole.

4. Rotate the cover plate so that it is upright.

5. Slide the plate so that it completely covers the hole.

6. If the plate is loose after installation. Gently press on the flexible bracket arms with both thumb and re-install the cover plate. NOTE : To remove the plate, do the steps in reverse order. Start with step 5 and finish with 3.