Cover-Plate Installation Instructions

1. Make sure the hole diameter is : diam ” . If the hole is too small enlarge as required. Be careful not to make the hole too large.

2. Remove the imperfections from the surrounding of the hole. This will allow the cover plate to lie flat against the wall.

3. Make sure that the inside of the hole is smooth. Remove any broken “Sheetrock/ Drywall” pieces.

4. Align the Cover Plate bracket with the circle center and insert it into the hole.

5. Rotate the plate so that it completely covers the hole.

6. If the plate is loose after installation. Gently press on the flexible bracket arms with both thumb and re-install the cover plate. NOTE : To remove the plate, do the steps in reverse order. Start with step 5 and finish with 3.